Assessment of tensile and fatigue behavior of PEEK in a physiologically relevant environment

Authors

  • Mirco Peron NTNU
  • Jan Torgersen
  • Filippo Berto

DOI:

https://doi.org/10.3221/IGF-ESIS.47.33

Keywords:

PEEK, Tensile, Fatigue, Notch, SED

Abstract

In the last decades the necessity of implant devices is continuously increasing. The researchers have thus focused their attentions on the development of new biocompatible materials, in particular polymers. Among them, polyetheretherketone (PEEK) has gained wide interest in load-bearing applications such as spinal cages due to its yielding behavior and its superior corrosion resistance. Since such applications are characterized by notches and other stress concentrators weakening the implant resistance, a design tool for assessing their tensile and fatigue behavior in the presence of such discontinuities is highly claimed. To this aim, tensile and fatigue data available in literature of neat and differently notched PEEK samples (circumferentially cracked and U-notched specimens with different notch radii) experimentally tested in a phosphate-buffered saline (PBS) at 37 °C have been analyzed using the strain energy density (SED) approach. The method is shown to provide accurate results regardless of the different notch geometries, both for tensile and fatigue data. Concerning the former, the tensile strength was in fact estimated with an error lower than ±10%, regardless of the strain rate, while for the latter the SED approach was able to summarize the fatigue data with a single narrow scatter band independently from the notch geometry

Downloads

Download data is not yet available.

Published

05-12-2018

How to Cite

Assessment of tensile and fatigue behavior of PEEK in a physiologically relevant environment. (2018). Frattura Ed Integrità Strutturale, 13(47), 425-436. https://doi.org/10.3221/IGF-ESIS.47.33

Most read articles by the same author(s)

<< < 1 2 3 4 > >>