Impact and Dynamics

All Items

• Introduction and application of a drive-by damage detection methodology for bridges using variational mode decomposition

  Shahrooz Khalkhali Shandiz, Hamed Khezrzadeh, Saeed Eftekhar Azam

  24-54

• Methodology to minimize the dynamic response of tall buildings under wind load controlled through semi-active magneto-rheological dampers

  Francisco da Silva Brandão, Alex Koch de Almeida, Letícia Fleck Fadel Miguel

  89-105

• Metastability, adiabatic shear bands initiation and plastic strain localization in the AMg6 alloy under dynamic loading

  Mikhail Sokovikov, Sergey Uvarov, Mikhail Simonov, Vasiliy Chudinov, Oleg Naimark

  255-266

• Effect of Pre-tensioning Force on Behavior of Buckling Restrained Brace (BRB) Supported by Double Pre-tensioning System

  Mohamed Selim, Muhammad E. Kamel, Eman Elshamy, Mohamed Emara

  205-216

• Behavior of Zr–1Nb alloy in coarse- and ultrafine-grain states under laser-induced shock wave loading

  Dmitry Ledon, Aleksandr Balakhnin, Sergey Uvarov, Irina Bannikova, Yuriy Bayandin, Oleg Naimark

  164-177

• Behavior of a Multi-Story Steel Structure with Eccentric X-Brace

  Abdulkhalik Abdulridha

  273-296

• An assessment of HDPE fillers and Fiber Wrapping on the strength of Reinforced Concrete

  Basavaraj Gudadappanavar, D K Kulkarni , Shivakumar Gouda

  240-249

• Impact behavior of gravity cast AlSi10Mg alloy: Effect of hot isostatic pressing and innovative high pressure T6 heat treatment

  Luca Girelli, Maverick Giovagnoli, Marialaura Tocci, Annalisa Fortini, Marcello Gelfi, Mattia Merlin, Annalisa Pola

  204-217

• Efficiency of shape memory alloy seismic restrainers for several conditions of bridge joints

  Mohamed Hamdy El-Feky, Atef Eraky, Alaa M. Sharabash

  104-120

• Evaluating the Safety and the Effect of Blast Loading on the Shotcrete together with lattice girder Support of Tunnels

  Farnoosh Basaligheh, Hamidreza Karimi Tabar, Majid Nikkhah

  121-136

• The earth-fill dam state express investigation using mechanical vibrations produced by HPP

  Galina Antonovskaya, Natalia Kapustyan

  46-60

• A simplified formula to estimate the load history due to ballistic impacts with bullet splash. Development and validation for finite element simulation of 9x21mm full metal jacket bullets

  Riccardo Andreotti, Andrea Casaroli, Mauro Quercia, Marco V. Boniardi

  602-612

• Finite-element study of residual stress distribution in Ti-6Al-4V alloy treated by laser shock peening with varying parameters

  Anastasiia Kostina, Maxim Zhelnin, Elena Gachegova, Alexander Prokhorov, Aleksei Vshivkov, Oleg Plekhov, Sathya Swaroop

  419-436

• A simplified constitutive model for a SEBS gel muscle simulant - Development and experimental validation for finite elements simulations of handgun and rifle ballistic impacts

  Riccardo Andreotti, Valentina Leggewri, Andrea Casaroli, Mauro Quercia, Cristian Bettin, Mauro Zanella, Marco V. Boniardi

  176-197

• Effect of beam-column joints flexibility on the seismic response of setback RC buildings designed according to the Algerian seismic code

  Abdallah Yacine Rahmani, Said Hicham Boukhalkhal, Mohamed Badaoui

  394-409

• Behavior assessment of asymmetrical building with concrete damage plasticity (CDP) under seismic load

  Patrick Oliveira Batista da Costa, Rúbia Mara Bosse, Gustavo de Miranda Saleme Gidrão

  108-118

• Impact behaviour of dissimilar AA2024-T351/7075-T651 FSWed butt-joints: effects of Al2O3-SiC particles addition

  Cindy Morales, Mattia Merlin, Annalisa Fortini, Gian Luca Garagnani, Argelia Miranda

  504-515

• Experimental and computational study on dynamic analysis of cracked simply supported structures under moving mass

  Shakti P. Jena, Cihan O. Bulut, Serpil Kurt

  114-133

• Optimization of a reinforced concrete structure subjected to dynamic wind action

  Jherbyson Brito, Letícia Miguel

  326-343

• Sensitivity analysis of the GTN damage parameters at different temperature for dynamic fracture propagation in X70 pipeline steel using neural network

  Abdelmoumin Ouladbrahim, Idir Belaidi , Samir Khatir , Erica Magagnini, Roberto Capozucca , Magd Abdel Wahab

  442-452

• Modelling of Low-velocity Impacts on Composite Beams in Large Displacement

  Mattia Utzeri, Marco Sasso, Gianluca Chiappini, Stefano Lenci

  254-271

• Damage severity for cracked simply supported beams

  Ehab Samir Mohamed Mohamed Soliman

  151-165

• Enhancement of Blast Resistance of R.C Beams Using Micro/Nano Silica in Presence of Steel Fibers

  Mahmoud Nawar, Kareem El-Awady, Hamdy Shehab, Ahmed Eisa

  259-280

• A Simplified ALE model for finite element simulation of ballistic impacts with bullet splash – development and experimental validation

  Riccardo Andreotti, Sergio Abate, Andrea Casaroli, Mauro Quercia, Riccardo Fossati, Marco V. Boniardi

  223-245

• Reliability and Reliability-based Sensitivity Analyses of Steel Moment-Resisting Frame Structure subjected to Extreme Actions

  Abbasali Sadeghi, Hamid Kazemi, Maysam Samadi

  138-159

• Impact response of different materials for sports mouthguards

  Maria Moreira, João Carlos Ramos, Ana Messias, Maria Augusta Neto, Ana Paula Amaro, Paulo NB Reis

  63-69

• Analysis of Above-Ground Steel Storage Tanks Resting Over Piles or Stone Columns

  Tarek Salem, Hassan Maaly, Ahmed Abdelbaset

  40-49

• Experimental analysis of the state of stress in a steel – titanium perforated plate loaded with concentrated force

  Mateusz Konieczny, Grzegorz Gasiak, Henryk Achtelik

  277-288

• Experimental and numerical optimization study of shock wave damping in aluminum panel sandwich

  Masoud Rahmani, Amin Moslemi Petrudi

  88-109

• An innovative fixture for testing the crashworthiness of composite materials

  Lorenzo Vigna, Iman Babaei, Ravin Garg, Giovanni Belingardi, Davide Salvatore Paolino, Andrea Calzolari, Giuseppe Galizia

  76-87

• Numerical analysis of underground tunnels subjected to surface blast loads

  Mahmoud Nawar, Alaa Ata, Marwa Nabil, Sally Hassan

  159-173

• Investigation of the effect of impact load on concrete-filled steel tube columns under fire

  Ali Golsoorat Pahlaviani, Ali Mohammad Rousta, Peyman Beiranvand

  317-324

• Vibration control in buildings under seismic excitation using optimized tuned mass dampers

  Francisco da Silva Brandão, Letícia Fleck Fadel Miguel

  66-87

• Numerical and analytical simulation of ballistic projectile penetration due to high velocity impact on ceramic target

  Amin Moslemi Petrudi, Khodadad Vahedi, Masoud Rahmani, MohammadAli Moslemi Petrudi

  226-248

• Shear behaviour of reinforced concrete beams under impact loads by the lumped damage framework

  Mateus Oliveira, Daniel Teles, David Amorim

  13-25

• Damage and failure of Orban’s gun during the bombardment of Constantinople walls in 1453

  Aristotle Kakaliagos, Nikolaos Ninis

  481-496

• The use of acoustic emissions technique in the monitoring of fracturing in concrete using soundless chemical demolition agent

  Vassilios Saltas, Despoina Peraki, Filippos Vallianatos

  505-516

• Numerical simulation of crack propagation behavior of a semi-cylindrical specimen under dynamic loading

  Ghorban Khandouzi, Mohsen Mollashahi, Mojtaba Moosakhani

  29-37

• Post- Impact Fatigue Damage Analysis of Quasi Isotropic CFRP Laminates through Infrared Thermography

  Raghu Vasu Prakash, Mathew John

  536-546

• Optimization of Vanadium Content for Achieving Higher Wear Resistance and Hardness in High Cr-V White Cast Irons for Ball Tube Mill Liner Application

  Dhirendra Kumar, G. Jayaraman, M. Swamy, Pavan A. H. V., Antony Harison M. C., A. N. Sudhakar

  507-514

• Response of fabric insert injection overmolding PP based composites subjected to single and muti-impact Impact response of fabric insert injection overmolding PP based composites

  José António Martins Ferreira, Tiago Febra, José Costa, Carlos Capela

  242-248

• Impact response of laminated cylindrical shells

  Carlos Alexandre Campos Pais Coelho, Fábio V.P. Navalho, P.N.B. Reis

  411-418

• Investigation on the static and dynamic structural behaviors of a regional aircraft main landing gear by a new numerical methodology

  F. Caputo, A. De Luca, A. Greco, S. Maietta, A. Marro, A. Apicella

  Pages 191-204

• Dynamic debonding in layered structures: a coupled ALE-cohesive approach

  Marco Francesco Funari, Fabrizio Greco, Paolo Lonetti

  Pages 524-535

• Investigation of stress intensity factor for internal cracks in FG cylinders under static and dynamic loading

  Mahmoud Shariati, Masoud Mahdizadeh Rokhi, Hassan Rayegan

  Pages 166-180

• Implementation of a damage model in a finite element program for computation of structures under dynamic loading

  Nasserdine Oudni, Youcef Bouafia

  pages 278-284

• Effect of inhomogeneous distribution of non-metallic inclusions on crack path deflection in G42CrMo4 steel at different loading rates

  S. Henschel, L. Krüger

• Development of an engineering methodology for non-linear fracture analysis of impact-damaged pressurized spacecraft structures

  Igor Telichev

  pages 24-34

• Experimental investigation of fibre reinforced plastics with hybrid layups under high-velocity impact loads

  Marco Romano, Carl J. J. Hoinkes, Ingo Ehrlich, Johann Höcherl, Norbert Gebbeken

  pages 385-398

• Impact loading of a space nuclear powerplant

  Evgeny I. Kraus, Ivan I. Shabalin

  Pages 138-150