Resilience and ductility of Oxy-fuel HAZ cut
DOI:
https://doi.org/10.3221/IGF-ESIS.30.03Keywords:
CuttingAbstract
Cutting processes affect the material to a deeper or shallower attached-to-the-cut zone. Its microstructure, its hardness and mechanical properties are changed. Also the cutting process introduces surface roughness and residual stresses. In most cases it is recommended to remove this region by grinding, in order to keep a smoother surface, free from the above mentioned effects. This work presents the characterization results of the Heat Affected Zone (HAZ) of a steel plate of grade S460M, with a thickness of 25 mm, cut by flame oxyfuel gas cutting. The HAZ microstructure is observed (and the depth of the HAZ measured), the hardness profile and the stress vs. strain curves until fracture are measured by testing micro-tensile samples, instrumented with strain gauges. Micro-Tensile specimens are 200 microns in thickness and were obtained from layers of the HAZ at different distances from the oxy-fuel cut. The obtained stress-strain curves are compared with the hardness measurements and the observed metallography.
Downloads
Published
Issue
Section
License
Copyright
Authors are allowed to retain both the copyright and the publishing rights of their articles without restrictions.
Open Access Statement
Frattura ed Integrità Strutturale (Fracture and Structural Integrity, F&SI) is an open-access journal which means that all content is freely available without charge to the user or his/her institution. Users are allowed to read, download, copy, distribute, print, search, or link to the full texts of the articles in this journal without asking prior permission from the publisher or the author. This is in accordance with the DOAI definition of open access.
F&SI operates under the Creative Commons Licence Attribution 4.0 International (CC-BY 4.0). This allows to copy and redistribute the material in any medium or format, to remix, transform and build upon the material for any purpose, even commercially, but giving appropriate credit and providing a link to the license and indicating if changes were made.